Material Safety Data Sheet
Section 1-Product Identification
Fett Affen Technologies
12558 7th St.
Yucaipa, CA. 92399
Trade Name: Gun-Werkz
Chemical Name: Proprietary
Part Numbers: 47-04FM, 47-08FM, 47-16FM, 47-16TS, 47-32TS, 47-32, 47-128
Dot Shipping Name: This product is not regulated by any mode of transportation.
HMIS/NFPA Code: Health 0; Fire 1; Reactivity 0
Date Prepared: 12-03-2010
|Section 2-Composition/Information on Ingredients|
|This product contains no hazardous materials per U.S. federal definitions (29 CFR1910.1200 Subpart Z)|
|Section 3 –Hazards Identification|
INHALATION: Negligible unless heated to produce vapors. Vapors may irritate the mucous membranes and cause irritation, dizziness and nausea. Remove to fresh air.
INGESTION: Do NOT induce vomiting unless instructed to do so by medical personnel.Seek medical attention immediately.
SKIN: Prolonged or repeated contact is not likely to cause skin irritation. Thermal burns are possible due to elevated temperatures of material if overworked.
EYE CONTACT: May cause irritation. Flush eye(s) with water for at least 15 minutes. Seek medical attention if symptoms persist.
CARCINOGENIC EFFECTS: NTP: No, IARC: No, OSHA: No
MUTAGENIC EFFECTS: None
TERATOGENIC EFFECTS: None
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: None
|Section 4 –First Aid Measures|
EYES: Remove contact lenses if present. Irrigate eyes with clean cool water at a low pressure for at least 15-20 minutes. Seek medical attention if irritation persists.
SKIN: Wash exposed areas of the skin with soap and water. Seek medical attention if irritation persists.
INHALATION: Move from area of exposure. Seek medical attention if breathing is difficult.
INGESTION: Give one or two glasses of water to drink. If gastro-intestinal symptoms develop, seek medical attention. (NEVER give anything by mouth to an unconscious person.)
|Section 5- Fire Fighting Measures|
COMBUSTION PRODUCTS: Carbon monoxide and carbon dioxide.
EXTINGUISHING MEDIA: SMALL FIRE: Dry chemical powder. LARGE FIRE: Water spray, fog or foam. (Water stream may splash the burning liquid and spread the fire).
SPECIAL FIRE FIGHTING MEASURES: Use water spray to cool any drums exposed to fire.
UNUSUAL FIRE HAZARDS: Soaked rags can spontaneously combust if stored near combustibles or not handled properly (i.e. wadded up and left unattended). Store used rags in an approved container and dispose of properly. Rags may be washed with soap and water and hung up to dry in a well ventilated area or outside.
PROTECTIVE CLOTHING (FIRE): Firefighters must use full bunker gear including NIOSH-approved positive pressure self-contained breathing apparatus to protect against potential hazardous combustion or decomposition products and oxygen deficiencies.
FLASH POINT: 130.0 C or 266.0 F min. (ASTM 93)
EXPLOSION DATA: None.
AUTO IGNITION TEMPERATURE: Not available
|Section 6- Accidental Release Measures|
Turn off all sources of ignition, stop leak where possible and contain spill to smallest area possible.
For a small spill, use absorbent materials and dispose of properly.
For a large spill, contain the spill using a dike method. Collect liquid for salvage or disposal. Soak up remaining liquid using absorbent pads, sand or other inert absorbent materials. Dispose of according to State and Local and Federal regulations.
Wash hard surfaces with a safety solvent or detergent to reduce the possibility of slippery surfaces.
|Section 7- Handling and Storage|
Store in closed containers between 50 and 120 degrees F.
Keep away for oxidizing agents, excessive heat and ignition sources.
Use only with adequate ventilation.
Store in a cool, well ventilated area.
Avoid breathing of vapors or spray mists.
Wash hands thoroughly with soap and water after handling.
|Section 8- Exposure Control/Personal Protection|
RESPIRATORY PROTECTION: If vapors or mist is present, wear a NIOSH approved organic vapor/mist respirator. Normal room ventilation is usually adequate. If necessary, use exhaust fans.
HAND PROTECTION: Use protective gloves when applying this product.
EYE PROTECTION: Safety glasses, goggles or face shield should be worn.
HYGIENE CONSIDERATIONS: Use protective clothing, wash contaminated clothing before re-use. Wash exposed skin thoroughly after handling.
|Section 9- Physical and Chemical Properties|
Boiling Point: 760 mm Hg:>200°C
Specific Gravity: 0.88-0.89 @ 20°C
Evaporation Rate: None.
pH: Not applicable
Vapor Density: Air =1:>1
Vapor Pressure: mmHg:<2
Solubility in Water: Insoluble
Physical State: Liquid
Odor: Slight mint
|Section 10- Stability and Reactivity|
Chemical Stability: This product is stable.
Incompatibility with Other Substances: Strong oxidizing agents.
Reactivity: Extremely reactive with oxidizing agents.
Hazardous Decomposition Products: Combustion produces carbon monoxide and carbon dioxide.
Hazardous Polymerization: Will not occur.
|Section 11-Toxicological Information|
Acute and Chronic Toxicity
Inhalation: Moderately irritating to the respiratory system.
Ingestion: No known significant effects or critical hazards.
Skin: Moderately irritating to the skin.
Eyes: Moderately irritating to the eyes.
If handled in accordance with good industrial hygiene practice, Gun-Werkz will not present a hazard in the workplace.
|Section 12- Ecological Information|
No Known significant effects or critical hazards.
|Section 13- Disposal Considerations|
|Waste Disposal: As per definition of RCRA, this product is not classified as hazardous waste. All waste and containers must be disposed of according to Federal, State and Local regulations. Avoid runoff and contact with soil, waterways, drains and sewers of any spilled material.|
|Section 14- Transport Information|
|This product is not regulated by any mode of transportation.|
|Section 15- Regulatory Information|
U.S. Federal Regulations:
TSCA 8(b) inventory: All components are listed or exempt.
RCRA Hazardous Waste No.: None
CERCLA Sections 102a/103 Hazardous Substances(40 CFR part 370): None
SARA 302/304/311/312 Hazardous Chemicals: 9-octadecenoic acid (z), methyl ester.
|Section 16- Other Information|
Notice to User: To the best of our knowledge, the information contained herein is considered accurate. However, neither the above named supplier nor any of its subsidiaries assumes ay liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of the suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist.
As with any fluids used for any purpose it is recommended that the use of appropriate gloves and eye protection by worn at all times. Use with adequate ventilation.